Inhalt: 40 ml
5,19 EUR *
16-20 Tage, abhängig von der Lieferfähigkeit des Herstellers
Grundpreis: 129,75 EUR / 1 Liter
Stk.

Mark Fit is a special solvent designed to soften your model decals which will allow you to apply them onto difficult to apply areas such as bumpy and curved surfaces. This "strong" version has a more powerful formula for softening decals compared to the standard version. The Strong version help decals adhere and conform to difficult curved surfaces or matte-painted surfaces. In addition, it could also help speed up the decal application process. The Bottle cap comes with brush applicator and contains 40ml of solvent.

Note: May cause damage to painted surface in some cases, particularly surfaces painted with acrylic paints.

How to Use

Apply Mark Fit solvent to area where decal is to be positioned. Place decal onto the area. Slide decal into correct position by a wet finger. Use a soft cloth or cotton swab to remove excess water and any air bubbles. Apply Mark Fit over the decal again, and then use a soft cloth or cotton swab to conform it to the model's surface. Do not touch until decal dries completely.



ACHTUNG: Modellbauartikel - kein Spielzeug. Nicht geeignet für Kinder unter 14 Jahren. -Gesundheitsgefährdend-


Sicherheitsdatenblatt
So stellen wir sicher, dass Bewertungen von echten Verbrauchern kommen.

 
 
 
  aus Zossen
  aus Warendorf
 
  aus Ostrhauderfehn